Sunday, 8 December 2019

Church

Ok, so about time I did a church...

An unusually appropriately targeted Facebook ad told of a sale on mdf scenery at Wargames Tournaments and a casual browse gave this little church for a tenner (and I think it was free postage as well), so as I pimp up mdf anyway, bare bones for a tenner worked for me...


It’s not bad for the money, the door will need cutting out, but that’s fine, and and laser cut brick texture would be covered anyway so the lack of that in this kit is fine as well. It’s just put together here, no glue as the pimping will be easier on flat pieces. There are decorative window trims as well.


The only two downsides I can see is that one tower wall is too short (above), but that’s fixable and I’m not sure how the roof goes together, no instructions came with it but the rest is obvious and I’ll probably have to tinker anyway as any wall pimping will need to be taken into account. All in all not too bad...

Just need to see the best way to get some big brick work on there.

3 comments:

Michael Awdry said...

Looking forward to seeing what you do with that.

Simon Quinton said...

Looks good so far.

Allison M. said...

Hmm... Nice model. You could go in a lot of directions with this.