Monday 29 July 2024

3D printed ruins

So, the end of last month was my birthday and I got a load of Amazon vouchers. Aside from the inevitable DVDs or books, although never my preferred gaming store, it’s sometimes worth a look. I’ve had some 3D printed barricades from Amazon before - painted for my stalled MC-1 project (not sure if I’ve ever shared them anywhere), but they’re decent for the price, as are these ruins which easily fill a gap in my terrain options.


Are they perfect? No. Could I make my own? Maybe, but I’m not replicating those pillars and arches over and over again. So these are decent. Layer lines are an issue close up, but they will look fine on the tabletop.


This large single piece is one set, the puddle base adds a bit of rubble, but the layer lines are a bit more obvious when you’re looking at higgledy piggledy blocks. So that was pimped with some texture paste initially and then with some Grimdark scatter from Krautcover (via Bad Squiddo). I used the dead static grass I’d used on the marshland to give a decayed “all is not well here” feel…


The vines were added to hide a frankly lazy bit of 3D sculpting present here and in one of the other pieces I got, where two elements form the corner and the arches bleed into each other. If QP3D should ever read this, you really should clean that up. You manage it on the T and X walls, but not on the L shaped walls.



So, the second set was a set of four, a straight and the aforementioned X, T and L walls. These are the same to all intents and purposes. Aside from the bleeding arch, the only real flaw is the straight isn’t very stable and the joy for me of these was the minimal basing. One nudge of the table and that will topple, so I added my own puddle base, tried to replicate the one on the large L and it’s nice and sturdy now.



As said before, the L has that bleed, so vines again.



And completely absent from the T and X.



And finally, a look at the tops. The sculpts had a kind of broken  mortar effect, which is a little visible in places, but the tops got hit with Grimdark cover and the dead grass. Quite happy with the final pieces.





As I said, available from Amazon or their own website (https://qp3dwargames.co.uk/) where these appear to be part of a nice pseudo Osgiliath range.

2 comments:

Michael Awdry said...

Fabulous job! I find the lines on 3D prints slightly off-putting, but the convenience and cost keeps me going back for another look. Some lovely little tips and tricks to try here though, thank you.

Allison M. said...

Layer lines? Who cares! These look amazing with your painting and embellishments. Those vines are genius and add so much. The grass on top really gives the look of age too. Fantastic terrain.